English translation for "source impedance"

电源阻抗
源阻抗

Related Translations:

line impedance:  线路阻抗

optimum impedance:  最佳阻抗

impedance dialling:  阻抗拨号

lumped impedance:  集总阻抗

synchronous impedance:  同步阻抗

spur impedance:  寄生阻抗

bilateral impedance:  双向阻抗

impedance level:  阻抗大小阻抗位准

soil impedance:  土壤阻抗

secondary impedance:  次级阻抗

Example Sentences:

	1.	This algorithm can be executed independently of the source impedance and fault resistance with an error less than 0 . 5 percent 该算法原理简单，求解方便，仿真结果表明，算法具有较高的精度，最大测距误差小于0 . 5 % ，能够满足工程要求。
	2.	The temperature rises and the dc voltage are proportional to the power dissipated , which is equal to the power of the source being measured if the input impedance is suitably matched to the source impedance 热偶冷热结之间的温度差和热电势均正比于耗散在ta2n电阻上的微波功率，如果热偶的工作电阻与同轴传输系统电阻匹配适当，该功率就等于被测源的功率。
	3.	Second , since input bias currents are not always small and can exhibit different polarities , source impedance levels should be carefully matched to minimize additional input bias current - induced offset voltages and increased distortion 其次,因为输入偏置电流不一定都小,且可能体现不同的极性，而且源阻抗水平应该仔细地进行匹配，以将输入偏置电流引起额外失调电压和增加的畸变减到最小。
	4.	This thesis presents a single - terminal fault location technique that is used together with recloser . the technique takes advantage of reclosing of single - terminal recloser to eliminate the influence of the remote source impedance . a distributed parameter line model is used for the proposed algorithm , thus the technique can be used in hv transmission line 为了克服这一缺点，本文提出了与自动重合闸配合使用的单端故障测距方法，根据电力系统的运行特点，利用故障线路在试送电时自动重合闸的单端重合状态来消除对端系统的影响，测距算法建立在分布参数模型基础上，使其可应用于高压输电线路。

Similar Words：

"source iaddress" English translation, "source identified" English translation, "source identified code sid" English translation, "source identifier" English translation, "source image" English translation, "source in" English translation, "source index" English translation, "source index register" English translation, "source indicator" English translation, "source information" English translation